Page 41 - Vauxhall 20-60 H.P. (R Type) Chassis Shop Manual
P. 41
VAUXHALL 20-60 SHOP MANUAL
The polished radiator shell is made of solid German Silver, and may therefore
be cleaned as often as necessary, without fear of the original bright finish
being affected.
CLEANING UPHOLSTERY
SECTION To keep Moquette or Bedford Cord upholstery in the best condition, it
153 should be cleaned at least once a month with a whisk broom and vacuum
cleaner. Dirt and grit accumulating in the fabric wear it out quicker than
actual use.
Spots on the upholstery may be removed with any good dry cleaner. When
the cleaner has thoroughly evaporated, apply a hot flat iron wrapped in a
wet cloth. Steaming the fabric and rubbing slightly against the nap will raise
the nap to its normal position.
Furniture hide and antique leather upholstery should be cleaned occasionally
with a good quality furniture cream, to keep it in good condition. The cream
should be applied sparingly with a flannel pad and afterwards polished with
a soft polishing duster.
BODY — TO REMOVE
SECTION – Remove spare wheel.
154 – Remove front floorboards.
– Disconnect positive lead from battery and lead from starter.
– Remove front seats, rear seats and rear squab.
– Remove bonnet.
– Disconnect dashboard-to-radiator tie rod.
– Disconnect oil pipe, petrol pipes and petrol gauge air line connections
at bottom of dashboard.
– Disconnect windscreen wiper pipe and Autovac suction pipe from
induction manifold union.
– Disconnect carburettor choke shutter control wire.
– Disconnect all leads from instrument board switch panel also leads
from horn. Disconnect speedometer cable.
– Remove eight bolts ( four each side ) holding the body to either side of
the chassis frame, also the bolt in each dashboard support bracket.
– Remove lower half of instrument board steering column support
bracket. Place suitable covering over steering wheel to prevent its
being damaged. With suitable overhead hoist raise body complete with
dashboard, push chassis clear and lower body on to suitable trestles.
TO REPLACE
SECTION To replace body, reverse operations given in ( Section 154 ). Do not connect
155 lead to battery until the body is finally at rest and all other electrical
connections have been made.
Page 37.